The vacuum cleaner is warranteed for 1 year from the date of purchase. Parts not covered under warranty are power
cords, filters, motor brushes and blades. The warranty covers only failure due to defective parts or workmanship and will
be invalidated by improper application and abuse.
Under no circumstances should you return a failed unit to the factory. If you experience any problems with your vacuum
during the warranty period, contact the Customer Service Department.
Limited Warranty
Maintenance
Brush Roll Belt Replacement
CAUTION!
Belt and pulley become hot during normal use.
The belt should be checked regularly to ensure proper cleaning. Replace belt if it appears stretched, cracked or is slipping.
Remove bottom chrome plate by turning the two cam locks on each side. Remove worn belt from drive motor pulley.
Remove brush roll from base, and slide off worn belt. Slip new belt around brush roll and reinstall into machine. Install
belt around drive pulley with low side in groove. Be sure belt is installed correctly or brush roll will turn in wrong direc-
tion. Replace chrome cover. NOTE: Be sure brush roll with offset belt drive is orientated correctly, with the shorter length
to the left. Arrows on brush roll end caps indicates the top of cap and shows installation direction. Cut away any hair or
thread wound around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly.
Brush Strip Replacement
Remove the bottom chrome plate by turning the two cam locks on each side and remove brush roll from machine. Also
remove nuts and end caps. Slide out worn brush strips and replace. Reassemble brush roll and reinstall in machine.
NOTE:
Brush strips come in different lengths. See arrow markings on brush roll end caps to confirm direction of brush
strips.
Fan Scroll
The clear plastic fan scroll attached to the underside of the base may be removed and cleaned. Remove the chrome plate
and brush roll belt from pulley. Remove the two screws on either side of the clear scroll, press the cam locks outward and
lift the scroll from the base. Remove any dirt and/or obstructions. Be sure the gasket is in place and the scroll is seated
properly before reattaching, then reinstall belt and chrome plate.
Carbon Motor Brush Replacement
Once a year or after 500 operating hours, have the motor carbon motor brushes replaced. Failure to service carbon mo-
tor carbon brushes will null and void warranty.