2
NOTE:
Ensure that Emitter is installed before power is
applied. Installing Emitter after power has been applied
may trigger the “end-of-lamp-life circuit” and the Emitter
may fail to light. If this happens, shut off power for 10
seconds and then turn power back on. Emitter will then
light.
CAUTION:
Do not drill into other electrical or
mechanical equipment. Consult all applicable codes before
installing. Check power supply housing label for the correct
power requirements. Obtain power from a suitable,
protected (fused) and grounded power source.
All access doors to the location where fixtures are
installed should be interlocked to turn Emitter(s) off when
doors are opened. Entry ways without doors should be
equipped with motion detectors to prevent entry during
operation. The door should have a sign posted in
appropriate languages alerting personnel to the possible
hazard of exposing eyes or skin to UVC energy. Doors
may be equipped with a glass window to view Emitters.
UVC energy does not penetrate common glass.
Viewports are available as an accessory through Steril-
Aire.
Consult all applicable codes before installing. Check
fixture label(s) for the correct power requirements and
supply the correct voltage from a suitable, protected
(fused), and grounded power source.
Hard Mount Option
Hard Mount Option Installation Kit includes the following
items:
ITEM
NO.
DESCRIPTION
QTY
1
DUAL DE422 PANEL
1
2
MOUNTING CHANNEL
2
3
TRUSS HEAD SCREW 10-32 X 1
6
4
CLIP NUT 10-32
6
5
GTD 40 VO SLEEVED EMITTER
or GTD 40 VO EMITTER
2
I
NSTALLATION
& O
PERATION
Step 4: Insert Fixture into hole attach with 6
each Truss Head Screws.
Using a qualified electrician, make the
electrical connection to the cables coming
from the ½” conduit nipple on the top
housing.
Do not turn power on
.
Step 3: Install 3 each Clip Nuts to the two
Mounting Channels; Install Channels into the
Edges of the Opening
Step 2: Remove Emitters and Reflective
covers from fixture.
Step 1: Cut out 8.1” x 42.3” hole in ceiling or
wall and drill 6 each 9/32 Ø holes per
drawing/template
