-12-
6. Straighten the red LEDs (Light-Emitting-Diodes) on the Circuit Board so that they are standing straight up
(they may have been bent to protect them during shipping). Place the Circuit Board into the Top Case,
components side facing you, as shown (it is aligned using 8 tabs on one side and 2 tall screw holes on the
other side). Make sure the red LEDs are still straight and will be visible from the outside and that you don’t
knock any of the buttons out of position. It is a good idea to elevate the unit enough so that it isn’t resting on
any of the buttons (otherwise, some buttons might be knocked out of position and won’t work properly).
Secure with 3 small side Screws (0.2” x 0.1” or 0.3” x 0.1”, from Bag #3) and then 9 large Screws (0.4” x 0.1”,
also Bag #3) as shown. Note that not all of the screw holes are used. Now flip the Top Case over and again
compare it to the picture of it on the box. It should look the same. Press each of the buttons to be sure they
depress properly. If not, unscrew the Circuit Board and check the arrangement of your buttons.
Figure G
Small Side Screws
Large Screw
Component
Side of the
PC board
CAUTION: IMPORTANT
Make sure that the PC board
goes under the tabs on the case
as shown.
Component
Side of the
PC board
Tab
Green Side
of the PC
board
LED
Содержание AK-900
Страница 24: ......