3-Axis TB6560 CNC Driver Board User Manual - ST-6560V3
4
Center wire of each coil not connected (insulate termination). Remaining wires are connected to their
corresponding terminal block location (i.e. A- wire is connected at A- location).
c. 8 Wire Stepper Diagram
2 center wires of each coil connected (insulate connection)
Remaining wires are connected to their corresponding terminal block location (i.e. A- wire is connected
at A- location).
If using 6 or 8 wire motors, connected using series wiring method, reduce labeled amperage rating by
50% (i.e. a motor rated at 4 amps should thus be considered now rated at 2 amps).
3.2 Connect to Computer by DB25
The following is to aid in the setup of the use of controller with various CAM software programs
operating on your computer.
