Issue 3
Page 4
18/06/2015
4.7 Noise
Ear protection may be required depending on the combined noise level of the generator,
auxiliary load and the operator’s distance from it and the length of exposure. (Noise at
Work Regulations 1989)
4.8 Battery Acid
This is corrosive and irritant by all forms of exposure. Direct contact should always be
avoided by wearing suitable rubber gloves. Some form of eye protection should also be
used. If skin contact is made wash with clean water.
4.9 Fire
Ensure that suitable fire extinguishers (AFFF or CO
2
)
are kept within proximity to the
generator. Do not cover, enclose, or obstruct the airflow to the generator during or shortly
after use, due to fire hazard or damage to the generator from overheating. Allow the
generator to cool after use before storing away. Keep all inflammable objects clear of the
generator.
4.10 Hot parts
There is the danger of
burns as parts of the generator will become very hot during use.
No part of the engine, alternator or exhaust must be touched during or shortly after
operation.
Do not operate the generator unless all guards are in place. There is a risk of burns or
serious personal injury.
5 Operating instructions
5.1 Pre-start checks
Before starting the generator please read the Kubota engine owners manual.
Check
Fuel
,
Water
&
Oil
level before attempting to start.
This engine is equipped with an oil pressure and water temperature switch and will
shutdown for low oil pressure and high water temperature.
If engine runs out of fuel do not attempt to start until fuel bowl is full of diesel this can be
achieved by pressing
Fuel Pump Prime
button until bowl is full of diesel. The engine
should then self bleed and start when you go through the starting procedure.
5.2 Warning
Do not operate the changeover switch with load connected.
Always switch load off before disconnecting plugs.
To switch power off at generator always use circuit breaker.
5.3 Control panel
The control panel has an “Emergency Stop” button which is
ONLY
for emergency use.
This generator is equipped with an RCD on the 230 Volt supply only.
Before connecting plugs into generator ensure the load is turned off.
If this is not possible turn the circuit breaker to the off position.
Turn the voltage selector switch to the required voltage.
Connect the plug/plugs into the generator.
Switch on the load / circuit breaker.
Always turn load off before stopping generator.
5.4 Long term storage
For storage or long periods of inactivity, Stephill Generators recommend the following:
Generators should be stored with oil filled to the correct capacity; Storage periods of 18
months and over may require special lubricants and treatments. If so please seek further
advice from the engine manufacturer.
Before the generator is used after long term storage, all fuels and oils should be replaced.
Generator mounts, pipes and hoses should be checked to ensure that they are un-
perished following extended periods of storage.
The generator should be stored in a clean dry area, ideally having a reasonable constant
ambient temperature, and ideally not below freezing.
