2
INSLAN0314
When cutting or drilling into a wall, be careful not to damage electrical wiring and other hidden utilities.
Because this unit is hot when in use, it may pose risks even in normal operation. Therefore,
be careful
and
responsible
when using it.
Never block air vents. This obstruction could lead to overheating, which could result in a fire.
Do not insert or allow foreign objects to enter any air vent as this may cause electric shocks, a fire, or damage to the unit.
This unit has hot and arcing or sparking parts inside. It is not designed to be used or stored in wet areas or areas containing flammable liquids, combustible
materials or corrosive, abrasive, chemical, explosive and flammable substances such as, but not limited to, gasoline, paint, chlorine, sawdust and cleaning
products.
Some areas are dustier than others. Thus, it is the user’s responsibility to evaluate if the unit
must be cleaned
based on the amount of dirt accumulated on
and inside air vents. Accumulated dirt can lead to a component malfunction or give a yellowish colour to unit. Failure to install and maintain unit in accordance
with these instructions poses a fire hasard.
Thermal protection activation indicates that the unit has been subjected to abnormal operating conditions. If the thermal protection remains activated or
activates and deactivates repeatedly, it is recommended that a qualified electrician or a certified repair centre examine the unit in order to make sure it is not
damaged. (Refer to the limited warranty)
If the unit is damaged or defective, cut off power supply at circuit breaker and call a certified repair centre. (Refer to the limited warranty)
installation
Suggested mounting height from bottom of dryer
MeN
45” (115 cm)
WoMeN
43” (110 cm)
TeeNAgeRS
41” (105 cm)
SMALL chILDReN
35” (90 cm)
hANDIcAPPeD
37” (95 cm)
MINIMUM heIghT
15” (40 cm)
Recommended fasteneRs
Masonry walls: 1/2” expansion sleeve with 1/4” lag bolt
hollow walls: 1/4” wing type bolts
Wood walls: 1/4” lag screw with washer
WarnInG
tecHnical draWinGs
Note:
When a part of the product specification must be changed to improve operability or other functions, priority is given to the product specification itself. In such
instances, the instruction manual may not entirely match all the functions of the actual product. Therefore, the actual product and packaging, as well as the name
and illustration, may differ from the manual.
FLOOR OR COUNTER
4"
102mm
11 7/16"
291mm
10"
254mm
4 1/2"
114mm
6 1/4"
160mm
8 1/4"
210mm
8 9/16"
217mm
8 3/8"
213mm
O
1/4"
6mm
TYP.
INSIDE
SIDE
FRONT
MIN 15''
[381mm]
