INSBFNHL1013
11
HEAT LAMP INSTALLATION
Screw a heat lamp (maximum 250W) (not included) into the appropriate socket.
TROUBLESHOOTING
Noisy fan
Fan not working
• Check ductwork
- Ensure that bents in ductwork are kept to a
minimum.
- Junction between the back draft damper and the
duct must be airtight.
- In the case of a flexible duct, ensure that it is not
sagging.
• Elbows angle must be greater than 90 degrees.
• Ensure that the outside hood is not blocked.
• Check for improper electrical wiring.
• Check that circuit breaker is in the ON
position
UL STANDARD 507 LISTED
CSA LISTED ACCORDING TO STANDARD C22.2 NO 113
ETL LISTED (3015005)
Stelpro Design inc.
1041, Parent Street
Saint-Bruno (Quebec)
J3V 6L7
Fig. 11.2
LIMITED WARRANTY
This product is guaranteed for a period of 1 year. If at any time during this period the unit becomes defective, it must be
returned to its place of purchase with a copy of the invoice, or simply contact our customer service department (with
a copy of the invoice in hand). The warranty is limited to the factory repair or the replacement of the unit, and does not
cover the cost of disconnection, transport, installation, and component replacement. Any damages or failures caused by
abuse, misuse, abnormal usage, faulty installation, or improper maintenance (other than that provided by Stelpro) will not
be covered by this warranty. Stelpro Design disclaims any responsibility for bodily injuries, losses of income and material
damages caused directly or indirectly by the product. Some States and provinces do not allow the exclusion or limitation
of incidental or consequential damages and some States do not allow limitations on how long an implied warranty lasts,
so these exclusions or limitations may not apply to you. This warranty gives you specific legal rights and you may have
other rights which vary from State to State and province to province.
8
