Page 25 of 37
939504740 Rev E
Strap Screw
24.
26.
Worksurface Screw
TIP:
Level the extension with the base by measuring the height from floor
(or top of foot casting). If not levelled, remove worksurface by undoing
all the worksurface screws; undo steps to remove mounting plates, pull
chain to adjust height. Repeat measurement above, do steps to attach
mounting plate and worksurface.
21.
Place extension surface onto connector
plates.
22.
Attach connector plates with connector plate
screws.
23.
Attach the strap using strap screws.
24.
Rotate extension base
slightly to line up with
the three pilot holes on the extension top and drive
worksurface screws.
25.
Tighten all loose mounting plate screws.
26.
Remove guides, retain for future assembly.
27.
Insert crank and rotate several times to
ensure that the unit adjusts properly.
