stellar labs Slider50, Руководство пользователя

Страница: 38 / 62

32 Slider50 Owner’s Manual
a. Before installing the pump to the PTO, always check the direction of the PTO output shaft to
determine which direction the hydraulic pump needs to rotate to operate the equipment. If
this is not determined prior to installing the hydraulic pump, the hydraulic pump may rotate in
the incorrect direction and damage the front shaft seal.
PTO Direction of Rotation Tip:
Viewed by standing at the rear of the vehicle, looking forward at the PTO shaft, with the PTO
shaft pointing toward the rear of the vehicle:
Remember that the PTO is specified by looking from the rear of the truck to the front of the
truck. The driven equipment (pump) is specified by looking from the front of the truck to the
rear of the truck.
b. Use the brand specific PTO/Pump installation instructions. If the directions are not quite clear,
contact Stellar® Customer Service or consult with a hydraulic specialty house or company
prior to installation.
Step 9: Install PTO and pump.
PTO
DRIVEN
EQUIPMENT
(PUMP)
DRIVEN
EQUIPMENT
(PUMP)
TRANSMISSION
TRANSMISSION
From rear of truck,
PTO shaft rotates
opposite engine/
clockwise.
From front of truck,
pump shaft rotates
counterclockwise.
From front of truck,
pump shaft rotates
clockwise.
From rear of truck,
PTO shaft rotates with
engine/counterclockwise.
PTO
P.T.O. Driven Equipment
Rotates Opposite Engine
(looks "clockwise)
Driven equipment must rotate
counterclockwise (also called left-hand
rotation, "A" for anti-clockwise or C.C.W. for
counter clockwise).
Rotates With Engine
(looks "counterclockwise")
Driven equipment must rotate clockwise
(also called right-hand rotation or "C" for
clockwise).