stellar labs Slider 20-S, Руководство пользователя

Страница: 29 / 46

Stellar
®
Slider20-S Owner’s Manual | Page 23
Step 15: Operate hooklift.
•
Stellar
®
Hooklift operators must conform to the qualifications specified
in the Slider Hooklift Safety, Operation, Maintenance, Troubleshooting Manual. Read and
understand all manuals and safety signs before operating or servicing this equipment.
• Bleed the air out of the hydraulic system.
• Check the hydraulic oil level and add oil if needed. When checking hydraulic oil level,
make certain that all system cylinders are fully retracted.
• Calibrate dump light system.
• Be sure to check all clearances.
• Set/check relief pressure no higher than 4500 PSI (See procedure on next page).
Step 14: Fill reservoir and activate hydraulic flow.
• Fill reservoir to site gauge, within 3” from the top (Roughly 25 Gallons). Note: ISO 32 hy-
draulic oil is recommended.
• When connections are secure, activate hydraulic flow by opening the ball valve on the
bottom of the reservoir. This will allow oil to flow from the reservoir to the pump.
WARNING
Set System Relief Pressure
1. Engage the PTO. Run the PTO at 1200 RPM.
2. Push the control lever labeled ‘lift’ until the boom bottoms out. Keep pushing the lever
forward until the pressure is set.
-
+
3. Locate the main relief valve and release the jam nut using a 13 mm
wrench.
4. Adjust the system relief pressure using 4 mm allen wrench. Clockwise in-
creases pressure, counter clockwise decreases pressure.
5. Once system pressure is set, tighten the jam nut to lock system pressure.
Permanent thread lock should not be used.
6. Release all functions and disengage the PTO. Snap tamper cap into position over the jam
nut. The break away clip will be destroyed if the cap is removed.