(E-34) 5 Series
You may mount the LED in the fog light bezel, or the rear cigarette bezel.
Cigarette Lighter Bezel
1.
Mount the LED in the cigarette lighter bezel at the rear of the center
console. ( Figure 13)
- Place a screwdriver along the bottom edged (along carpeting) and lift
up carefully.
- Disconnect cigarette lighter wiring.
2.
Drill a hole for the LED.
3.
Mount the LED in the hole and run the wires to the receiver which is now
mounted under the rear seat.
4.
Plug in the LED terminal into the receiver.
Go to " Siren Installation" Pg. 6
Fog Light Bezel
1.
Mount the LED in the foglight switch bezel on the dash.
(Figure 14)
- Place a screwdriver along the right side and lift up carefully.
- Disconnect cigarette lighter wiring.
2.
Drill a hole for the LED.
3.
Mount the LED in the hole and run the wires to the receiver which is now
mounted under the rear seat (you will need to extend the wire).
4.
Plug in the LED terminal into the receiver.
Go to " Siren Installation"
5
Fig 12
Remove
Knock Out
Panel
BMWSTX Receiver
LED Harness
Fig 13
Cigarette
Lighter
Bezel
LED
Fig 14
Foglight Switch Bezel
LED
4.
Run the LED wires to the receiver which is now mounted in the glove box.
(Figure 12)
5.
Plug in the LED terminal into the receiver.
Go to " Siren Installation" Pg.
6
REV2 5.12.03
bmwstx 5/10
RECIEVER
INSTALLATION GUIDE
automotive security systems
(E-36) 3 Series ( Except 318ti & Z3)