Steiner 75-71231, Руководство владельца/оператора и иллюстрированный перечень запчастей

Страница: 12 / 32

STEP 3
ADJUSTMENTS
Drive pulley adjustment:
NOTE
: Place the tractor horizontally on a flat surface.
1. The tractor pulley (item 60) and the snowblow-
er pulley (item 61) must be well aligned (dis-
tance B must be close to 0’’ as possible) Make
sure there is no contact between the two belts
when the snowblower is in the highest position.
2. For tractor without electric clutch : do the
same tests as in snowblower installation
section, step 9. If the snowblower starts and
proper tension is used, the pulleys are mis-
aligned too much.
If at the highest position the two belts come
into contact with each other, there is not enough
space between the pulleys.
3. On 440 tractors, to prevent snowblower from
contacting front of tractor during full lifts, po-
sition the lift cylinder and pin into the bottom/rear
hole on the lift arm as shown on picture:
NOTE : Failure to position the lift cylinder as shown
can result in damage to the tractor and or the snow-
blower.
Skid shoe adjustment:
LEVEL PAVED SURFACE: Adjust skid shoes to allow 3/16” to 1/4” clearance between cutting edge and
surface.
UNEVEN OR GRAVEL SURFACE: Adjust skid shoes to allow 1/2” to 3/4” clearance between cutting edge and
surface.
When you have confirmed the alignment, put thread
locking on set screw and torque at 183 lbs-in.
STEP 4
SNOWBLOWER REMOVAL INSTRUCTIONS:
1. Lower parking stand.
2. Lower the snowblower and stop engine
TO PREVENT INJURIES: STOP THE MOTOR. APPLY PARKING BRAKE. REMOVE THE IGNITION KEY.
DISCONNECT THE WIRE FROM THE SPARK PLUG(S) AND KEEP AWAY FROM SPARK PLUG(S) TO
PREVENT ACCIDENTAL STARTING
.
3 .Disconnect the two hydraulic hoses and install dust covers.
4. Remove the drive belt and release the quick hitch. Start the engine and back out carefully.
5. Remove the weights from the weight bar for the 4 wheel drive unit.
10
ADJUSTMENTS & REMOVAL