Software
UR44C Operation Manual
12
Meter Window
This window is for showing the meter at the top of the Main
window.
1
Level Meter
Indicates the signal level. Peak hold is normally set to on.
Setup Window
This window is for configuring the common settings of the
device.
1
Device
Selects the device when simultaneously connecting one
or more devices that are capable with dspMixFx.
2
Device Settings
Opens the Control Panel.
3
HPF Setting
Selects the cutoff frequency of the high pass filter (not
available on [LINE INPUT 5/6]).
Options:
120 Hz, 100 Hz, 80 Hz, 60 Hz, 40 Hz
4
Line Input Level
Selects the input signal level of [LINE INPUT 5/6].
Options:
+4 dBu, -10 dBV
5
Zoom
Changes the window size.
Options:
100%, 150%, 200%, 250%, 300%
6
Knob Mode
Selects the method of operating the knobs on dspMixFx
UR-C.
7
Slider Mode
Selects the method of operating the sliders and faders on
dspMixFx UR-C.
8
About
Indicates the version of the firmware and software.
Display color
Description
Green
Up to -18dB
Yellow
Up to 0dB
Red
CLIP
1
1
8
5
2
3
6
7
4
Settings
Description
Circular
Drag in a circular motion to increase and
decrease the parameter. Drag on a dial
clockwise to increase, and counterclockwise to
decrease. If you click any point on the knob,
the parameter will jump there instantly.
Linear
Drag in a linear motion to increase and
decrease the parameter. Drag upward or
rightward to increase, and downward or
leftward to decrease. Even if you click any point
on the knob, the parameter will not jump there.
Settings
Description
Jump
Click any point on the slider and fader to
increase and decrease the parameter. If you
click any point on the slider and fader, the
parameter will jump there instantly.
Touch
Drag the handle of the slider and fader to
increase and decrease the parameter. Even if
you click any point on the slider and fader, the
parameter will not jump there.
