Steinbach 040916, Оригинальное руководство пользователя

Страница: 24 / 210

Before First Use
WARNING!
Risk of death when operating the water treatment system during bathing.
Hair or clothing might get sucked into the suction openings of the pool and in extreme cases
trap persons under water and prevent them from surfacing again.
-
Never operate water treatment system devices while persons are in the pool.
-
Prevent any access to the pool for as long as water treatment system devices are in use.
Check the following before start-up
- The device is out of the pool and the power cable is disconnected from the mains
Initial start-up of the timer
The timer is going to function flawlessly even if you do not perform the steps described below. However,
should the power supply be interrupted, the saved filter running times will be lost.
1. Make sure that the pump's power cable is disconnected from the power supply.
2. With a Phillips screwdriver PH1 , remove the screws of the timer cover and take the cover off.
3. Pull out the strip of plastic from underneath the battery.
4. Screw the cover back on.
The timer's memory backup function is activated.
Preparing the pump
At the time of delivery, the pump is only partially assembled.
Only hand-tighten all screw connections. Excessive tightening of the screw connections
damages gaskets and plastic components. Do not use any tools.
You can use Teflon tape to seal screw connections with minor leakage.
1. Loosen the threaded ring
1
on the prefilter
cover
2
by turning it counterclockwise.
2. Lift the prefilter cover
2
with the threaded
ring off the pump housing.
3. Insert the large O-ring seal
3
into the
groove on the pump housing.
4. Insert the prefilter
11
into the pump.
The prefilter is already inserted into the pump
at the factory.
5. Place the prefilter cover
2
on the pump
housing.
6. Guide the threaded ring over the prefilter
cover.
7. Turn the threaded ring clockwise until it is
hand-tight.
8. Insert the small O-ring seal
7
into the prefilter cover.
9. Screw the hose adapter
6
clockwise into the prefilter cover until it is hand-tight.
10. Place the medium O-ring seal
5
into the recess of the pump outlet
10
.
11. Screw a hose adapter
6
clockwise into the pump outlet until hand-tight.
The pump is ready for operation. You can now connect it to the lines.
1
1
2
3
11
5
7
10
6
24