Steinbach 040120, Оригинальное руководство пользователя, Страница: 31 / 273

Preparing the pump
At the time of delivery, the pump is only partially assembled.
Only hand-tighten all screw connections. Excessive tightening of the screw connections
damages gaskets and plastic components. Do not use any tools.
You can use Teflon tape to seal screw connections with minor leakage.
1. Loosen the threaded ring
13
on the prefilter
cover
11
by turning it counterclockwise.
2. Lift the prefilter cover
11
with the threaded
ring off the pump housing.
3. Insert the large O-ring seal
16
into the
groove on the pump housing.
4. Insert the prefilter
21
into the pump.
The prefilter is already inserted into the pump
at the factory.
5. Place the prefilter cover
11
on the pump
housing.
6. Guide the threaded ring over the prefilter
cover.
7. Turn the threaded ring clockwise until it is
hand-tight.
8. Insert the small O-ring seal
18
into the prefilter cover.
9. Screw the hose connection clockwise into the prefilter cover until it is hand-tight.
10. Place the medium O-ring seal
17
into the recess of the pump/pressure line connection
22
.
11. Screw a hose adapter
12
clockwise and hand-tight into the pump/pressure line connection.
The Active Balls 50 filter system has the hose adapter assembled on the pressure hose.
The pump is ready for operation. You can now connect it to the lines.
Mounting the pump on the base plate
1. Insert the threaded screws of the screw set
for fastening the pump
19
from below into the
two hexagonal holes in the base plate
9
.
2. Place the pump
10
on the base plate
9
so
that the threads protrude through the
fastening opening in the pump base.
3. Push the washer and then the serrated lock
washer over the screw thread.
4. Put on one winged screw each and tighten it.
The pump is mounted on the base plate.
5. Connect the base plate
9
to the filter vessel
6
.
The base plate is connected to the filter vessel.
1
13
11
16
21
17
18
22
12
2
10
2
9
19
3
6
9
31
en