PRODUCT BRIEF INTRODUCTION
[ 5 ]
PRODUCT BRIEF INTRODUCTION
[ 6 ]
4.2 Output signals
1.FRONT1/A+B To Midrange
FRONT2/C+D To Tweeter
Rear/E+F To Midbass
Subwoofer /G+H To Subwoofer
2.USB
USB(type B)connection plug, to connect the processor to a PC and manage its funcitions
through the DSP 3 Software. The connection standard is USB 1.1/2.0 compatible.
4.3 Input - remote control outputs and power supply
1. POWER SUPPLY
.
+12V
:Positive connection terminal for car 12V power supply.
GND
:Power supply negative connection terminal(GND).
WARNING:
make sure the connection polarity is as indicated on the terminals.A misconnection.
May result in damage to the DSP. After applying power,wait at least 10 seconds
Before turning the DSP on.
2. OPTICAL INPUT
WARNING
:the DSP must be switched on before any amplifiers are turned on.
The system sources Remote Out must be connected to the product REM IN,and the product
REM OUT. is then to be connected to the Remote In of other devices/amplifiers.
5.CONNECTIONS
5.1 Power supply and remote turn on
WARNING:
to power the device,use 1 mm (16 AWG) cables.
Remark:
the DSP is intermally protected by a
Fuse-resistor soldered on its printed circuit board
To replace it contact a service center. Using an
External fuse is recommended, though it is not required.
2
MASTER-INPUT
1.post GND
2.post +12V
3.post REM IN
4.post REM OUT
1
REM IN
REM OUT
REM IN
REM OUT
REM IN
REM OUT
REM IN
REM IN
REMOTE OUT
-BATT
Ground
+ BATT +12V
16 AWG
Fuse Holder
Not Provided
Suggested Fuse
T1A-delayed
+
-
12V
Ground
2
1
2
