Espire Elbow Setup
7.
Temporary assembly to
test functionality
Connect the input accessory wires
to the input connector board on the
top of the Espire Elbow. Connect the
output wires to the terminal devices.
The wires will be labeled for easy
identification and any unused plugs
on the input board will be covered.
8.
Install battery
Insert the battery into the elbow, ensuring that the pull tab is
accessible for future removal. Then, apply the battery cover.
The battery cover clip will “click” into place when seated.
9.
Power on Espire Elbow
Feature
Description
Power Button
Press and hold for 4 seconds to turn Espire ON or OFF
Note: For detailed assembly information, refer to the
Espire Elbow Technical Manual - Pro and Hybrid
.
10.
Pair Espire Elbow to iPad
When the Espire Elbow is powered on, it will automatically
send a Bluetooth signal for 2 minutes. Press the search
button on the Hub App to begin pairing.
Note: iPad must be within about 10 metres/33 feet of
the Espire Elbow.
11.
Verify configuration reflects correct setup
Note: If the configuration on the home screen or
connections screen is incorrect, contact Steeper
Customer Services.
Home Screen
Once the device is connected, you wil land on the Home
Screen. The right side of the screen will display the
configured devices. These are setup by Steeper Group prior
to shipment, based on the information given during the order
process.
Location Information
1
Configured Input Devices
2
Configured Terminal Devices
3
System Settings
Connections Screen
Select the icon in the upper right of the home screen to open
the System Settings menu, then tap Connections.
The Connections screen displays an image of the Espire
Elbow’s input connector board. Here you can verify that the
inputs have been installed correctly.
12.
Congratulations!
The Espire is ready for patient fitting. Remember to charge
both batteries fully before delivering the prosthesis.
Note: For detailed App instructions including
troubleshooting info, refer to the
Espire Elbow Hub
App Instructions - Pro and Hybrid
.
Pull Tab
Battery Cover Clip
A B C D
1
11
12
2
3
4
9
10
6 5 8
7
3
1
2
EMERGO EUROPE
Prinsessegracht 20, 2514 AP The Hague, Netherlands
Australian Sponsor, EMERGO AUSTRALIA
Level 20, Tower II, Darling Park, 201 Sussex Street, Sydney, NSW
2000 Australia
MADE IN THE UK
©2020 Steeper Group
All rights reserved.
Steeper Group, Unit 3 Stourton Link,
Intermezzo Drive, Leeds, UK, LS10 1DF
Steeper Group
Unit 3 Stourton Link, Intermezzo Drive
Leeds, LS10 1DF
Tel: +44 (0) 870 240 4133
Email: [email protected]
SteeperUSA
8666 Huebner Road, Suite 112
San Antonio, TX 78240
Tel: (+1) 210 481 4126
Email: [email protected]
STPPR132
