BM-7
BM-7
Operator’s Manual
12
3.3. Adjusting the bevel width
Unplug the power cord. Loosen the clamping screw (
1
) and turn the sleeve (
2
) so
that the scale (
3
) shows the required bevel width. Tighten the screw.
3.4. Adjusting the guide for beveling with radius
Unplug the power cord. Then, loosen the clamping screw and turn the sleeve to set
the surface (
1
)
on the height of the end of the
cutting
edge
(
2
). You can also use an
optional radius insert positioner to set the guide correctly. Tighten
the screw. Bevel a
test edge, and if necessary adjust the position of the guide again.
2
1
1
2
3
Содержание BM-7
Страница 5: ...BM 7 BM 7 Operator s Manual 5 1 4 Dimensions 339 mm 13 11 32 319 mm 12 9 16 135 mm 5 5 16 ...
Страница 11: ...BM 7 BM 7 Operator s Manual 11 To install the milling head continue in the sequence that follows 1 2 3 4 5 6 ...
Страница 18: ...BM 7 BM 7 Operator s Manual 18 6 WIRING DIAGRAM ...
