JS647530
SETUP,
OPERATION &
PREVENTATIVE
MAINTENANCE
3
• Study, understand, and follow all instructions before operating this device.
• Do not exceed rated capacity.
• Use only on a hard, level surface.
• Support the vehicle with appropriate means immediately after lifting.
• Do not move or dolly the vehicle while it is on the jack.
• Lift only on areas of the vehicle as specified by the vehicle manufacturer.
• No alterations shall be made to this product.
• Failure to heed these markings may result in serious personal injury and/or
property damage.
• Prior to each use, visual inspection (see pg. 4) shall be made to the device by
checking for abnormal conditions, such as cracked welds, leaks, and damaged,
loose, or missing parts.
• Consult the vehicle owner’s manual to determine the location of lift points.
• Be sure to set the vehicle in park with the emergency brake on and wheels
securely chocked.
.• Be sure that the vehicle and the jack are on a hard and level surface.
• Turn the handle/release valve clockwise to the closed position.
Do not overtighten.
• Position the jack under the specified lift point.
• Begin lifting by pumping the handle up and down.
• Immediately after lifting, support the vehicle with appropriately rated
jack stands.
• Turn the handle/release valve slowly counter-clockwise to lower thwe vehicle
onto jack stands.
• Turn the handle/release valve clockwise to the closed position.
Do not overtighten.
• Pump the handle up and down to lift the vehicle off jack stands.
• Remove the jack stands. Do not get under or let anyone get under the vehicle
while lowering.
• Turn the handle/release valve slowly counter-clockwise to lower the vehicle
to the ground.
NOTICE: Use high grade hydraulic oil only. Never use brake fluid, motor oil,
transmission fluid, turbine oil or any other fluids. ISO-VG22 or equivalent hydraulic oil is
recommended.
CHECK AND REFILL OIL
• With the jack in the fully lowered, level position, if unit cover is provided,
remove unit cover, then remove oil filler plug.
• Proper oil level should be just covering inner cylinder as seen from the oil filler
plug hole.
SETUP
LIFTING
LOWERING
MAINTENANCE
• If two piece handles are provided, assemble the upper section into the lower
section, line up the holes, and insert and tighten the screw.
• Insert the bottom end of the handle into the handle fork and securely tighten
the bolt and washer. Ensure the handle can turn freely.
ASSEMBLY
