ST1008 Mini Wood Lathe
-15-
Test Run
4. Remove switch disabling key, as shown in Figure
12.
DO NOT start machine until all preceding setup
instructions have been performed. Operating
an improperly set up machine may result in
malfunction or unexpected results that can
lead to serious injury, death, or machine/prop-
erty damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run the machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation, and
then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
5. Try to start machine with paddle switch. The
machine should not start.
— If the machine
does not
start, the switch dis-
abling feature is working as designed.
— If the machine
does start
, immediately stop
the machine. The switch disabling feature
is not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
Figure 12. Removing switch key from paddle
switch.
Once assembly is complete, test run the machine to
ensure it is properly connected to power and safety
components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
