STEELE PRODUCTS SP-PT211, Руководство пользователя

Страница: 10 / 15

Circular Saw
10
Parallel cut adjustment
1. Loosen the edge guide locking screw.
2. Slide the edge guide through the slots in the shoe to the desired width.
3. Tighten the lock screw to secure it in the position.
4. Ensure that the edge guide rests against the wood along it entire length to give a consistent
parallel cuts.
Switching on and off
Note: Before engaging the on/off switch, check the saw blade to see if it is fitted properly and runs
smoothly, and the blade clamp screw is well tightened.
1. Connect the plug to the power supply.
2. To start the tool, depress the lock-off button and pull the switch trigger.
3. Release the trigger to turn the tool off.
Depth Adjustment
1. Loosen the depth adjustment screw using the depth locking lever.
2. Hold the base plate flat against the body of the work piece and lift the body of the saw until the
blade is at the right depth.
3. Tighten the depth locking lever.
Angle adjustment
1. Loosen the angle locking knob.
2. Adjust the shoe to the desired angle between 0ºand 45º.
3. Retighten the angle locking knob.
Note: for best cutting results, always ensure that saw blade protrudes no more than 3mm below the
bottom surface of the workpiece.
OPERATION