13
Drill (cont’d)
Variable speed control
Apply light pressure to the trigger to start the drill at a slow speed. Increasing
pressure on the switch increases the speed of the drill.
Forward and
reverse switch
Control the drill’s direction using the
slide switch located above the trigger.
Reverse:
To reverse the drill
rotation, push the button all the way
in on the left side.
Forward:
To return to forward
rotation, push the button all the way
in on the right side.
Place the directional control switch in the middle (neutral) position to prevent
accidental starting while carrying the drill. Never carry the drill with your finger on
the trigger.
trigger
directional control
19.2V Cordless Drill
Owner’s Manual
14
Drill (cont’d)
Torque adjustments
This feature allows you to set the torque
(tightening power) of your drill/driver
depending on your specific application and
amount of driving power required. Driving
large-diameter screws requires greater torque
power to properly seat the screw.
The chuck stops rotating when the selected
torque is reached.
There are 24 torque settings:
1-4:
For driving small screws.
4-8:
For driving screws into soft materials or plastics
9-12:
For driving screws into soft woods.
13-16:
For driving screws into medium/hard woods.
16-20:
For driving screws into hard woods.
21-24
: For powerful screw driving or drilling metal or using spade (hole) bits.
Note: Always start on the lowest setting. The drill symbol gives the
highest torque setting and is used when drilling larger holes and/or for
driving larger screws.