STEELE PRODUCTS PARADISE GS-32, Инструкция по эксплуатации и установке

Страница: 25 / 35

Fuel (Gas) Conversion Instructions for Paradise Grilling Systems Gas grills.
CAUTION:
This should only by performed by a licensed gas professional.
NATURAL GAS TO PROPANE CONVERSION - Main Burners:
Currently all grills are supplied with a regulator set at a pressure of 4” water column.
Fuel Conversion of Main Burners:
1.
Determine the existing gas type (LP or Natural gas). The process for changing the gas type (orifice
change-out) is the same for both gases.
2.
You must remove all cooking grills and flame tamers to expose the main burners in the grill.
3.
On the bottom rear of each burner is a screw. Remove screw.
4.
To remove burner, slide burner toward the rear of the grill and upward. Repeat for each burner.
5.
Where the burner was previously located, connecting to the main valve through the hole in the basin,
should now be evacuated space.
6.
Inside the space you will find the end of the valve (toward the front of grill), with an orifice (brass
fitting), screwed into the end of the valve stem.
7.
Carefully remove the orifice with a 7mm socket set and extension. *These are extremelyfragile!
When unscrewing, be extremely gentle, for you could easily break the brass fitting and have to
replace the valve).
8.
Once the orifice is removed, replace it with the new change-out orifice, (repeat for all burners).
When re-installing orifice, do not over tighten or you will strip the brass fitting. Only little pressure
is needed!!!
9.
Replace burners and test for proper flame height. Flame should stand between ½” - 1” on LOW and
1.5” - 2” on HIGH. (To adjust the LOW flame setting simply light the grill on the LOW setting and
adjust the screw which is located under the knob on the front of the valve as seen in the diagram
below.)
Low flame setting
screw
Paradise Grilling Systems Instructional Book