3” BULL BAR
2018 JEEP WRANGLER JL 4DR & 2DR
Page 1 of 4
3/2/18 (DP)
PARTS LIST:
1
3" Bull Bar
4
10mm Lock Washers
1
Driver/Left Mounting Bracket
2
10mm Plastic Retainers
1
Passenger/Right Mounting Bracket
2
10mm Hex Nuts
2
10mm Bolt/10mm Nut plates
4
8-1.25mm x 35mm Hex bolts
4
10-1.5mm x 35mm Hex Bolts
4
8mm x 24mm x 2mm Flat Washers
4
10mm x 30mm OD x 2.5mm Flat Washers
4
8mm Lock Washers
1
Allen Wrench S=4
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY. CUTTING IS REQUIRED. ASSISTANCE IS
RECOMMENDED.
2.
Remove the plastic splash guard from under the front bumper and place it on a clean, stable
work surface,
(Figures 1 & 5)
. Models with steel skid plate, skid plate must be removed and
cannot be reinstalled.
Models with plastic splash guard:
a.
Starting on the passenger/right side, locate the lower hex shaped hole in the outside of the
frame,
(Figure 2)
. Insert (1) 10mm Bolt/Nut Plate, (end with welded nut first), into the open
end of the bottom of the frame and push the welded hex bolt through the hex shaped hole,
(Figure 3)
. Thread (1) 10mm Plastic Retainer onto the Bolt/Nut Plate to hold it in position.
NOTE
: Plastic Retainer is designed to hold the Bolt Plate in position to help with Bracket
installation. Use is not mandatory.
IMPORTANT
: Remove the steel frame bracket for the
splash guard if more room is necessary to install the Bolt/Nut Plate,
(Figure 1)
.
b.
Select the passenger/right side Mounting Bracket,
(Figure 4)
. Attach the Bracket to the Bolt
on the Bolt Nut Plate with (1) 10mm Flat Washer, (1) 10mm Lock Washer and (1) 10mm
Hex Nut. Leave loose at this time. Grab the threaded end of the 10mm Bolt/Nut Plate and
rotate it until the top end with the welded Nut lines up with the round hole in the outside of
the frame and the top mounting hole in the Bracket. Attach the Bracket to the Bolt/Nut Plate
with (1) 10mm x 35mm Hex bolt, (1) 10mm Lock Washer and (1) 10mm Flat Washer,
(Figures 4 & 7)
. Snug but do not fully tighten Bracket hardware at this time.
Reinstall the
steel frame bracket for the splash guard if previously removed.
Driver/Left
Mounting Bracket
Passenger/Right
Mounting Bracket
(2) 10mm Bolt/Nut
Plates
