Wide Position
Narrow Position
Arm
Attachment
Screws
3
2a
2c
2b
A
Page 12 of 19
939546506 Rev E
Removal & Installation of the Arms
Prior to October 3, 2005
Removal:
1.
See page 11 for removal of the seat slide stop
blocks.
2.
Lift the seat slide lever (2a) and slide the seat
frame forward (as shown on page 8) until you can
see the arm attachment screws (2b). Remove arm
attachment screws with a torx T30 or #3 phillips
screwdriver (or Allen wrench) (2c).
3.
Slide the arms out. Note which hole the arm
screw was in. (Arms are shipped in the wide
position).
Installation:
Slide the new arm in and align the correct position
hole. Tighten until fully seated using a torx T30
screwdriver (or Allen wrench). Repeat for the
opposite side. Slide the seat frame back and
re-install both seat slide stop blocks and the T20
torx screws as shown on page 8. Make sure not to
strip the screws (hand tighten).
A.
When arms are not in use, a plug may be
inserted as a decorative effect (lightly tap).
DECORATIVE
PLUG
