Page 2 of 4
939504576 Rev H
3" or 9"
Pop rivets
(step 4)
Skin
Attachment
Slots
3/8" long screws
(Step 1)
3/8" long self-drilling
screws (step 2)
Bracket (step 1)
Dual Lock Pads (Step 3)
3/16" long screws (Step 3)
Illustration #2
Illustration #3
Illustration #1
1.
Install brackets with 3/8" long screw, 3" in from the
end of the frame, two places. Note: If your frame has no
hole 3" in from the end, look for the next hole at 9". Then
move the dual lock on the Slatwall Skin over 9" from the
end. See illustration #2.
2.
Use the self-drilling screw to provide a second
attachment point for the bracket. See illustration #2.
3.
Attach dual lock pads to brackets with 3/16" long
screws. See illustration #2.
4.
Position the Slatwall Skin with the hinge open, (90
o
)
so that the holes align. Rivet into place using the holes
in the frame. Lower series of holes on the hinge used
only when installing slatwall on the uppermost rail of a
2" Segment. See illustration #1.
Notes:
1. Make sure that the hinge on the slatwall skin does not
cross over the off-module slots in the frame when riveted.
2. Support channels on the back of the "A" skin may need
to be repositioned to miss hardwire (electrical) comp-
onents
when installed in the upper beltway zone.
