Page 3 of 15
939500267 Rev H
2.
Align the canopy assembly to
the back assembly (2a).
Make sure holes on the canopy
assembly accept the pins and
dowels on the back assembly (2b).
Draw each cam lock, in a clockwise
direction, into the center of the cam
0º to 75º (no tightening occurs at
this point). The cam lock range for
tightening is 75º to 195º. Hand
tighten until a rigid tensioning is
achieved in both cam locks (2c).
Install a canopy strap between the
canopy assembly and the back
assembly with two (2) #8-15 x 5/8"
pan head wood screws as shown
(one side only) (2d).
Install eight (8) shelf support pins
onto the canopy assembly (2e).
2a
2e
CANOPY
ASSEMBLY
BACK
ASSEMBLY
®
2b
2d
2c
CANOPY
ASSEMBLY
BACK
ASSEMBLY
CANOPY STRAP
