Steelcase Ology, Руководство пользователя

Страница: 12 / 14

TROUBLESHOOTING
SYMPTOM POTENTIAL CAUSE POTENTIAL SOLUTION
Circuit breaker
on treadmill trips
when the power
cord is plugged
in to wall
Restricted belt or flywheel Check and remove obstruction or call
dealer.
Treadbelt over-tensioned See page 09 for treadbelt adjustment
information.
Damaged motor *Service required.
Damaged or defective
motor power supply board
*Service required.
Damaged motor control
circuit board
*Service required.
Computer
display LEDs do
not illuminate
Control Panel wire harness
not connected or not
completely connected
Check that upper wire harness is
connected completely.
No power to treadmill Restore power at electrical outlet or reset
circuit breaker if in on/off position.
Circuit breaker trip Reset circuit breaker.
Treadbelt tracks
left to right
Uneven floor Move treadmill to even surface or level
with shims. See page 09 for treadbelt
adjustment information.
Rear roller not properly
adjusted
See page 09 for treadbelt adjustment
information.
Treadmill feet not seated
properly in treadmill
Move treadmill feet so both are seated
through holes in treadmill receiver plate.
Treadbelt feels
unsmooth, jerks
intermittently
Object between belt and
deck
Remove object between belt and deck.
Object under belt Remove object from under belt.
Loose treadbelt tension See page 09 for treadbelt adjustment
information.
Loose tread motor drive
belt
*Service required.
Squeaking noise
while using the
treadmill
Treadmill feet not seated
properly in treadmill
receiver plates
Move treadmill feet so both are seated
through holes in treadmill receiver plate.
Poly v-belt slipping *Service required.
Motor brush noise
excessive
*Service required.
Treadmill does
not turn on
Unit and table aren’t
plugged in to a working
electrical outlet
Restore power at electrical outlet or reset
circuit breaker if in on/off position.
Insecure cable
connections
Secure cable connections.
*Service to be performed by an authorized service provider.
12