3/32"
Assembly Directions
93-9500974 REV A
Page
2 of 6
NOTES:
1. The following assembly steps apply to either a right or left hand 41-ATT unit. A left hand unit is shown for all instructions.
2. A steel top has been shown. When assembling a wood top, the same instructions apply.
3. If the unit is assembled on a non-carpeted floor, we recommend you cushion the top with cardboard.
4. If your unit has been pre-assembled, begin with Step 4.
ASSEMBLING RETURN UNIT END PANEL TO TOP
Place end panel over pre-drilled holes in end of top
and install (2) 1/4 x 1” hex head screws.
NOTE: Use (2) channel spacers when attaching an end panel
to a 4200 top.
1.
PACKAGE CONTENTS
QTY.
DESCRIPTION
1
TOP
1
BACK PANEL
1
END PANEL & LEG ASSEMBLY
1
BOTTOM PANEL PLATE (FIG. C)
1
BOTTOM PANEL PLATE (FIG. D)
1
MOUNTING BRACKET
4
#10-24 HEX NUTS
2
#10-24 X 3/8” MACHINE SCREWS
4
1/4 X 1” HEX HEAD SCREWS (6 REQUIRED FOR WOOD TOP)
1
HANGER BRACKET
1
TWIN SPEEDNUT
2
CLIP ANGLE (NOT REQUIRED FOR WOOD TOP)
2
1/4-20 X 1-1/4” ROUND HEAD MACHINE SCREW (NOT REQUIRED FOR WOOD TOP)
3
#10 X 1/2” SHEETMETAL SCREW
2
#10 X 1/2” HEX HEAD SCREW
1
SLOPE TRAY ASSEMBLY
1
TYPE PAD
2
CHANNEL SPACERS (USED ON 4200 ONLY)
CHANNEL SPACERS
4200 ONLY
ATTACHING BACK PANEL
Fasten back panel to top with (3) #10 x 1/2”
sheetmetal screws. Before tightening screws be
sure to have a 3/32” overhang between the back
panel and end of top.
NOTE: Use (3) “Z” brackets when attaching back panel
to a 4200 top.
2.
Z BRACKET
4200 ONLY
