Page 3 of 4
003876D Rev T
®
Insert screws into bottom of monitor arm.
Allow two (2) fasteners to protrude approx.
1/4". These will be fully tightened after Step 2.
Slip bracket over screw heads (from Step 1)
using the keyhole slots. Slide brackets
together and tighten two (2) screws.
Guide two (2) flat head screws through bracket
and partially thread T-nuts onto screws. Note proper
orientation of T-nuts.
Place arm/bracket assembly onto desk rail. Tighten
two (2) flat head screws and T-nuts from Step 3.
Max. Torque 40 in-lbs (4.5 Nm).
Install locking plate onto face of assembled bracket.
Install and tighten final screw.
1
2
1
2
3
4
5
Install upper arm as shown.
6
Install VESA monitor plate as shown.
7
See note
below
Some models will
require this screw
to be installed by
the end user.
Frame One
Rail
Assembled and In position
on Frame One Rail
SIDE VIEW
5
3
3
4
6
7
FYI Single Monitor
Arm with Frame
One Bracket
FPASINGLEFO
NOTE:
Located in Monitor
Arm Hardware Pack.
100 - 105 in-lbs
(11.3 - 11.9 Nm)
T-NUT
FLAT SIDE TO
FACE BRACKET