2
of
3
939501047 Rev B
Refer to recommended work surface height
chart below. After selecting the desired
height of work surface,measure up from the
floor and place a pencil mark of piece of
masking tape on panel upright to indicate
where the top of cantilevered end support
assembly must be located.
1.
Hold cantilevered end support assembly in
a vertical position and insert tabs into slots
between panel upright and panel surface.
Push down engaging tabs into slots until
retainer lock snaps into place.
NOTE: The top of cantilevered end support
assembly must be aligned with pencil mark
or bottom of tape.
2.
RECOMMENDED WORK SURFACE HEIGHT
TYPING HEIGHT
26-3/4”
TYPING HEIGHT
27-3/4”
TYPING HEIGHT
28-3/4”
STANDARD DESK HEIGHT
29-3/4”
1-3/8"
