2
1-800-348-5004
IMPORTANT SAFETY INFORMATION
1.
TO PREVENT STEAM BURNS, DO NOT OPEN CAP OF HOT OR WARM RADIATOR.
2.
Pressurize only with hand pump. Do not use engine to pressurize system.
3. Loosen the radiator cap slowly.
4. Keep away from hot engine parts and fluids.
5. Use this product only according to these instructions. Improper use can create hazards.
6. Wear ANSI-approved safety goggles and heat resistant work gloves during product
assembly and use.
7. Refer to the vehicle’s service manual for specific radiator pressure testing instructions
before use.
8. Clean up coolant spills immediately. Dispose of fluids according to local, state, and
federal codes and regulations.
9. Keep work area clean and well lit.
10. Do not overreach. Keep proper footing and balance at all times. This enables better
control of the product in unexpected situations.
11. Keep bystanders out of the area during assembly and use.
12. Do not assemble or operate when tired or when under the influence of drugs or
medication.
13. This product is not a toy. Do not allow children to play with or near this product.
14. Use as intended only.
15. Inspect before every use. Do not use if parts missing or damaged.
16. WARNING: The brass components of this product contain lead, a chemical known to
the State of California to cause cancer and birth defects or other reproductive harm.
(California Health & Safety Code § 25249.5, et seq.)
17. WARNING: This product contains di (2-ethylhexyl) phthalate (DEHP), a chemical
known to the State of California to cause cancer and birth defects or other
reproductive harm. (California Health & Safety Code § 25249.5, et seq.)
18. Maintain product labels and nameplates. These carry important safety information.
If unreadable or missing, contact FOT for a replacement.
OPERATING INSTRUCTIONS
1. Refer to the vehicle’s service manual for specific radiator pressure testing instructions.
2. Loosen the vehicle’s radiator cap slowly to relieve any excess pressure before
removing the cap completely. Do not open the cap of a hot radiator.
3. Select the Proper Adapter and configuration of the Stationary Seat accessories.
Securely attach the adapter to the filler neck of the radiator or expansion tank.
4. Attach the Quick Connector of the Hand Pump onto the Adapter.
5. Rapidly pump the Hand Pump while watching the pressure gauge. Pressurize the
radiator up to the optimal pressure only - Do not over pressurize the radiator.
Readings normally range 12 ~15 PSI. If the pressure level is too low, there may
be a leak in the radiator or hose.
6. Once the test is complete, release the air pressure by pressing the Pressure
Release Valve on the Hand Pump. Then disconnect the Quick Coupler and
Adapter assembly.
7. Store the Kit in its Case in a clean, dry, safe location out of reach of children.
