MAINTENANCE AND SERVICING
1.
Before each use:
Inspect the general condition of the Vacuum Pump. Check for misalignment
or binding of moving parts, cracked or broken parts, damaged Hoses, loose connections, and
any other condition that may affect its safe operation. If a problem occurs, have the problem
corrected before further use.
Do not use damaged equipment.
2.
When cleaning:
Do not clean the Vacuum Pump with cleaners or other solvents. Use a clean,
dry cloth.
Do not immerse the Vacuum Pump in any liquid.
3.
When storing:
Do not store fluid in the Cup. Dispose of excess fluid properly, according to
federal, state, and local guidelines. Store the Vacuum Pump in a clean, dry location out of
reach of children.
4.
WARNING! All maintenance, service, or repairs not listed in this manual are only to
be attempted by a qualified service technician.
6
1-800-348-5004
9. Release the vacuum in the Vacuum Pump (1) with the Vacuum Release Valve.
Then, disconnect the Brake Bleed Screw Adapter (9) from the vehicle’s brake caliper bleed
screw.
Note:
Do not allow the cup to fill completely with brake fluid. When necessary, release the
vacuum in the tool and empty its Cup (3) of old brake fluid. To assist in transport, this
set includes a Transport Lid (2b) without hose connections. After the brake fluid is disposed
of properly, resume bleeding the brakes.
10. Remove the cap from the vehicle’s master cylinder, and refill the master cylinder back to its
normal capacity with clean, new brake fluid. Then, replace the cap on the master cylinder.
11. Proceed to the vehicle’s next brake caliper, and perform the same steps as above.
12. When finished using the Vacuum Pump, clean the tool and store it in a clean, dry location
out of reach of children.
13.
WARNING! Before driving the vehicle, carefully check for leaks and test for proper
brake operation.
