Steel City TITANIUM 50-510, Руководство пользователя

Страница: 11 / 40

Page 11
◊ INSTALLING / REPLACING
SANDING BELT
1. Disconnect machine from power source.
2. Open the left access door; turn the belt tension
knob ( A ) to the ‘OFF’ position (left) to release pressure.
3. Remove the pad lock lever ( B ) by turning it
counterclockwise and pull it up.
4. Remove the pad block ( C )
5. Remove existing belt (if present).
6. Make sure the direction of the arrows on the inside
of the belt matches the direction of rotation of the
machine (counter-clockwise). The edges of the
sanding belt should not be chipped or torn. Insert the
new belt starting first on the upper roller, then the lower
roller and center the belt while avoiding contact with the
limit switch fingers located on each side of the belt.
NOTE: the sanding belt must be centered between
the limit switches (D) and the edge of the belt must
be between the tongs of the oscillation controller
(E) before tensioning the belt, or damage may
occur tothe belt or to the sander when turned ON.
7. Replace pad block ( C ) and tighten pad lock lever ( B ).
8. Turn ON the belt tension knob ( A ).
9. Make sure there is clearance between the belt edges
and the limit switch finger on either side. If not, make
the appropriate belt corrections following the above
procedure (with air tension turned OFF) as necessary.
NOTE: the machine will not start if there is no
tension on the belt or if a limit switch is
depressed.
A
B
C
D
E