Steel City 65105, Руководство пользователя

Страница: 12 / 24

12
GROUNDING INSTRUCTIONS
ELECTRICAL REQUIREMENTS
TO PREVENT electrical shock, follow all electrical and
safety codes, including the National Electrical Code
(NEC) and the Occupational Safety and Health
Regulations (OSHA). All electrical connections and
wiring should be made by qualified personnel only.
TO REDUCE the risk of electrical shock, DO NOT use
machine outdoors. DO NOT expose to rain. Store
indoors in a dry area.
DO NOT connect the machine to the power source
before you have completed the set up process. DO
NOT connect the machine to the power source until
instructed to do so.
This machine MUST BE GROUNDED while in use to
protect the operator from electric shock.
In the event of a malfunction or breakdown, GROUND-
ING provides the path of least resistance for electric
current and reduces the risk of electric shock. This
machine is equipped with an electric cord that has an
equipment-grounding conductor and a grounding plug.
The plug MUST be plugged into a matching electrical
receptacle that is properly installed and grounded in
accordance with ALL local codes and ordinances.
If a plug is provided with your machine DO NOT modify
the plug. If it will not fit your electrical receptacle, have
a qualified electrician install the proper connections to
meet all electrical codes local and state. All connections
must also adhere to all of OSHA mandates.
IMPROPER ELECTRICAL CONNECTION of the equip-
ment-grounding conductor can result in risk of electric
shock. The conductor with the green insulation (with or
without yellow stripes) is the equipment-grounding con-
ductor. DO NOT connect the equipment-grounding con-
ductor to a live terminal if repair or replacement of the
electric cord or plug is necessary.
Check with a qualified electrician or service personnel if
you do not completely understand the grounding
instructions, or if you are not sure the tool is properly
grounded.
PLUGS/RECEPTACLES
• Electrocution or fire could result if this machine is
not grounded properly or if the electrical configura-
tion does not comply with local and state electrical
codes.
• MAKE CERTAIN the machine is disconnected
from power source before starting any electrical
work.
• MAKE SURE the circuit breaker does not exceed
the rating of the plug and receptacle.
The motor supplied with your machine is a 120 volt,
alternating current, 60 hertz, single phase motor. It is
shipped wired for 120 volt application. Never connect
the green or ground wire to a live terminal.
This tool is intended for use on a circuit that has an
electrical receptacle as shown in Figure 1-1. Figure 1-1
shows a NEMA approved 3-wire, 15 amp electrical plug
and receptacle that have a grounding conductor. If a
properly grounded electrical receptacle is not available,
an adapter as shown in Figure 1-2 can be used to tem-
porarily connect this plug to a 2-contact ungrounded
receptacle. The adapter has a rigid lug extending from it
that MUST be connected to a permanent earth ground,
such as a properly grounded receptacle box. THIS
ADAPTER IS PROHIBITED IN CANADA.
WARNING
WARNING
WARNING