Page 12
BASIC FEEDER AND SUPPORT
ASSEMBLY MOVEMENTS
Make certain that both machines are disconnected
from the power source.
1. To rotate the entire stock feeder assembly, loosen
locking lever (
A
) on the base and swing the assembly
into desired position.
See Fig. 7
2. To raise or lower the stock feeder (
G
), loosen the
locking lever (
C
) and turn the handle (
D
) to obtain
desired height.
3. To move the stock feeder (
G
) in or out, loosen locking
lever (
E
) and turn the handle (
B
) to extend or retract.
4. To adjust the stock feeder (
G
) in relation to the table
or to the fence, loosen locking lever (
F
) or (
H
) and
move the feeder into desired position.
WARNING
!
WARNING
!
Fig. 7
D
F
C
B
E
H
A
G
5. Make sure to tighten all locking levers after
adjustments are complete and prior to use the
stock feeder.
FEED RATE ADJUSTMENTS
WARNING
!
Make certain that both machines are disconnected
from the power source and that the feeder switch is
in the OFF position.
The 65-150 Stock feeder has 4 speeds available –
(20, 26, 33, 43 ft/min.) – (6, 8, 10, 13 m/min.) –
depending on gear arrangement. The speed chart
is attached inside the gearbox cover
See fig. 9
and
4 gears are provided (20, 24, 26, 30 teeth).
1. Unscrew the knob and remove the gearbox cover.
2. Remove the hex nuts and washers (
C
) securing
the gears.
Fig. 8
Fig. 8
C
B
A
3. Remove the gears (
A
) (
B
) from the shafts and
reposition as per the chart for desired speed.
4. Reinstall the washers and hex nuts and tighten.
5. Reinstall the gearbox cover.
Fig. 9 Speed chart
ADJUSTMENTS
Содержание 65-150
