Steel City 45925C, Руководство пользователя

Страница: 17 / 44

17
ASSEMBLY
‡ The table saw is a heavy machine; two people may
be required for certain assembly operations.
s
DO NOT assemble the table saw until you are sure
the tool is unplugged.
s DO NOT assemble the table saw until you are sure
the power switch is in the “OFF” position.
‡
For your own safety, DO NOT connect the machine to
the power source until the machine is completely
assembled and you read and understand this entire
User Manual.
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
CABINET LEG ASSEMBLY
C
WARNING
!
WARNING
!
NOTE: Use FIG. 1 as a referencing guide.
1. Remove all the doors and panels.
2. Lay the saw on back. CAUTION: The table saw is
heavy; two people are required for this operation. Be
sure to lay cardboard on the floor to protect the table
and cabinet. Use wedge to have an angle.
3. Install Primary Dust Chute and the 4” Dust Adapter
Port.
4. Attach four leg assemblies (A) to the cabinet by using
8 of each: Soc Screws, Nuts, Lock Washers and Flat
Washers. Do not completely tighten hardware at this
time.
5. Attach two U-shape front/ back panels by using 4 of
each: Carriage Screws, Lock and Flat Washers.
Fig. 1
L
C
F
L
K
D
A
B
J
E
H
I
G
6. Attach Wheel Kit by using Pan Head Allen Screws
(10) and Flat Washers (2) on bottom of Legs.
7. Attach Corss Brace by using M6x16mm Pan Head
Screws (4) and Lock Washers.
8. Attach the Flip Wheel to the cross bracket by using
Carriage Screws (2) and Lock Nuts (2).
9. Attach two Leveling Feet with Nuts (2).
10. Tighten all hardware, starting at cabinet. With help,
place machine upright. SEE FIG. 2
HANDWHEEL ASSEMBLY
1. Place one of the handwheels (A) onto the blade
raise/lower shaft (B) located on the front of the cabinet.
Align the groove in the back of the handwheel with the
pin (C). SEE FIG. 3
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE
.
WARNING
!
Fig. 3
A
C
B