Steel City 40630CH, Руководство пользователя

Страница: 19 / 31

19
NOTICE:
This operations section was designed to
give instructions on the basic operations of this jointer.
However, it is in no way comprehensive of every jointer
operation. It is strongly recommended that you read
books, trade magazines, or get formal training to
maximize the potential of your planer while minimizing
the risks.
STARTING AND STOPPING JOINTER
1. The on/off switch (A) Fig. 8A is located on the front of
the jointer. To turn the machine "ON", move switch
(A) up to the "ON" position.
2. To turn the machine "OFF", move the switch down to
the "OFF" position. The switch can be locked by
taking off the switch key as shown on Fig. 8B
DEPTH OF CUT
The depth of cut can be adjusted by positioning the
infeed table with respect to the cutterhead. Infeed table
can be raised or lowered by turning the handwheel.
Turn the locking knob counter-clockwise to loosen the
table leadscrew. When the table is set to be at the
desired height level, turn the locking knob clockwise to
secure and lock the table in position.
Turning the handwheel counter-clockwise will lower the
infeed table. This causes more wood to be removed from
the workpiece. By turning the handwheel clockwise will
raise the infeed table, which results in less wood to be
removed from the workpiece.
NOTE: Do not make jointing or planing cuts deeper than
1/8”.
Fig. 9
A
A
Fig. 10
A
A
OPERATIONS
MAKE CERTAIN THAT THE MACHINE IS DISCON-
NECTED FROM THE POWER SOURCE.
WARNING
!
Fig. 8A
Fig. 8B
A
MAKE CERTAIN THAT THE MACHINE IS DISCON-
NECTED FROM THE POWER SOURCE.
WARNING
!
CHECK THE DEPTH OF CUT
=
extending over the infeed table. Align both tables to the
same height.
^ @
NOTE: This jointer will make a maximum 1/8” deep cut.
To reduce any danger of kickback and possible injuries, it
is recommended to take cuts of 1/16” or less.
POSITIONING FENCE
The fence can be adjusted to cut any angle from 0°-45°,
inward and outward. The fence can be tilted inward up to
45° (towards the cutterhead) to maintain greater stability
of a narrow workpiece. The fence can also be tilted up to
45° outward (away from cutterhead) for larger angle
cutting operations.