Steel City 35619, Руководство пользователя

Страница: 17 / 40

17
ASSEMBLY
INSTALLATION AND LEVELING
Final location for the saw must be level, dry, well light-
ed, and have enough room to allow movement around
the saw with long pieces of wood stock.
Level the saw front to back and side to side, using a
carpenter’s level placed on the table. Use shims under
the corners, if necessary, but make sure the saw is
stable before being placed into service.
Fig. 1
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
MOTOR COVER ASSEMBLY
Install motor cover (A) by aligning the pins on the motor
cover (C) with the holes in the cabinet (B). Lower the
pins into the holes.
SEE FIG. 1.
EXTENSION WING ASSEMBLY
NOTICE: There is a specific Left wing and Right wing.
When attaching the wings to the saw, MAKE CERTAIN
that the beveled edges of the wings face towards the
front of the saw.
1. Attach extension wing to the table with three hex
head bolts, three lock washers, and three flat wash-
ers. Snug but do not tighten.
2. Slide the beveled end of the extension wing
towards the front edge of the saw table until the
beveled edges are flush.
3. Using a straight edge (A), align the extension wings
to the saw table and tighten the hex head bolts.
SEE FIG. 2.
MOTOR BRACE DISASSEMBLY
The red motor brace (A) is installed for shipping pur-
poses only. Remove this brace before assembling
the saw.
SEE FIG (A).
Fig. A
Fig. 2
A
WARNING
!
4. Repeat Steps 1-3 for the other wing.
C
B
A
A