Single Phase
Connections Shown
Power Supply
L1 and L2
Ground
Optional Steamist Splitter
for two Controls
Modular Jack
Protective Covering
“Remove Before
Installation”
Plug
Optional Auto
Drain Connection
Before starting, insure that the conditions of the following checklist have been met:
The proper size Steam Generator has been selected by
using the sizing page in the
“Full Line Brochure,” “Pricing
Guide,” or “The Generator Sizing Guide”
in the
Residential Systems/Steambath Product Information
section of the Steamist web site - www.steamist.com.
CAUTION:
An improperly sized Steam Generator will
NOT
produce the amount of steam necessary to reach
selected temperature.
The proper voltage Steam Generator has been selected
(i.e., 208V or 240V). A 208V generator operating on
240V will damage the heating element and a 240V
Generator operating on 208V will result in a 25% loss of
power.
The Steam Generator is installed in an upright position.
The proper sized 90°C wire and circuit breaker have
been used.
The circuit breaker is
NOT
a
GFI (Ground Fault
Interrupter) type.
The Steam Generator is properly grounded.
The circuit breaker or disconnect switch is on.
Water Supply is open to the Steam Generator.
Checklist
Knock-Out
for Auto Drain
¾“ Steam
Outlet
Safety
Relief
Valve
Water Inlet
⅜“ Compression
Fitting
½“ Out
When not equipped
with Auto Drain leave
drain line capped
and closed
Printed
Circuit
Board
Water
Level
Probe
Contactor / Relay
07/07
Pub. No. 323-H
- 2 -
Terminal Strip
for Auto Drain
Connection
