SV8D Quick Start Guide
Tel: 1300 79 50 50 E-mail:
Web: www.steamaustralia.com.au
1
SV8D
SV8D Display
SV8D Hose Controls
_______________________________________________________________________________________________
Preparing the SV8D
Steam Operation:
1. Plug cable into a wall outlet.
NOTE:
Do NOT use
multi-outlet power-boards and avoid using low-quality
extension cables.
2. Open water tank filler cap (
iii
), fill tank with clean tap
water up to the top then close filler cap.
NOTE:
Do NOT
use de-mineralised water and do NOT fill with any
chemicals.
3. Turn SV8D on using the ON/OFF switch (
i
), making
sure the steam level lights on the display (
g
) lights up
after a few seconds.
4. Connect hose into the SV8D by opening the
protective plastic flap located on the front of the
machine (
ii
) and pushing the plug end of the hose in
with the round red button on the top side of the hose
until it clicks.
Proceed to “Vacuum Operation” and/or “Detergent
Operation
” section
if you are planning on using the vacuum
and/or detergent functions together with the steam
functions.
Vacuum Operation:
1. Turn the vacuum on from the hose controls by quick-
pressing (
V
).
The SV8D will make a beeping noise and the vacuum
waste tank lights (
b
) will flash
on the display.
2. Open the transparent
vacuum cover (
iv
), remove
blue foam filter and slowly fill
clean tap water into the
rectangular hole on top of the
vacuum waste tank until the
vacuum waste tank lights (
b
)
stops flashing.
3. Replace the blue foam filter
and the transparent vacuum cover (
iv
).
NOTE:
If the vacuum waste
tank lights (
b
) still flashes after
filling the tank up, remove the
plastic
part
with
the
rectangular hole, then remove
the plastic divider underneath.
You will see a white float,
make sure the white float’s
surrounding areas and the
float itself is clean and can
move freely. Re-assemble the waste tank, fill the tank
with clean tap water until the vacuum waste tank lights
(
b
) stops flashing then put the blue foam filter and
transparent vacuum cover (
iv
) back on.
Detergent Operation:
1. Open transparent vacuum
cover (
iv
) and locate the
detergent tank filler cap.
2. Remove the detergent tank
filler cap and fill with the
diluted 101 degreaser solution.
NOTE:
We recommend
using
Steam Australia’s
101 degreaser or similar to
ensure it does not impact machine operation and/or
cause adverse health issues.
3. Replace the detergent filler cap and the transparent
vacuum cover (
iv
) before operating.
Hose Handle Operations
Steam Functions:
1. After 5-6 minutes the
‘Steam Ready’
lights (
d
) will
light up on the display and the steam function is ready
for use. Make sure the steam level lights (
g
) is on,
otherwise quick-press the
RED
steam button (
S
) until
the steam level lights turn on to prepare the steam
function for use.
2. If the SV8D makes a be
eping noise and the ‘Low
Water
’
lights (
c
) flashes, proceed to Step 2 of
“Preparing the SV8D | Steam Operations”.
[S]
[L]
[V]
[T]
[i]
[ii]
[iii]
[iv]
[f]
[g]
[a][b][c][d]
[e]
