PEGASO SVD Quick Start Guide
Tel: 1300 79 50 50 E-mail:
Web: www.steamaustralia.com.au
2
Hose Handle Operations
Steam Function:
1. After approx. 10 minutes, check that the machine
has reached pressure. Ready light will be illuminated
and the digital display shows that the boiler
temperature reaches at or above 170
C.
2. If the PEGASO makes a be
eping noise and the “Tank
Level”
LED (
d
) flashes, proceed to Step
2 of “Preparing
the PEGASO
| Steam Operations”
(
page 1
).
3. For S/V Hose, press and hold the trigger (
T
) to
activate the steam function. For S/O Hose, toggle the
steam on/off switch (
h
) to activate an automatic
stream.
4. Adjust the steam level from the knob (
e
). Turning
clockwise will increase steam level, turning counter-
clockwise will decrease it.
WARNING: Do NOT operate hose with steam nozzle
pointing at persons, animals or electrical machinery
/equipment/outlets/sensors that are sensitive to
water and heat (especially near fire alarm sensors).
Vacuum Function:
1. Plug the S/V Hose into the PEGASO.
2. Press the vacuum button (
f
)
to engage the vacuum
function. The vacuum will turn on and you will feel
suction from the vacuum nozzle.
NOTE:
Ensure that you regularly empty out the
contents of the vacuum waste bucket for a smooth
operation and change the HEPA filter located under
the vacuum head inside of the bucket if it is worn out
or too stained.
Detergent Function:
Press and hold the detergent button (
g
for S/V Hose,
k
for S/O Hose) to activate the detergent function.
If the detergent runs low in the PEGASO, the hoses
will stop spraying detergent. This is noticeable when
using the steam function in conjunction with the
detergent function as only the drier steam sprays out
the nozzle when the detergent function is activated.
Proceed to Step 1
–
3 of “Preparing the PEGASO |
Detergent Operation”
(
page 1
) if this happens.
Warning Lights
The PEGASO will make a beeping noise and a red LED
light will flash when the water tank’s level is low:
For water tank low level, refer
to Step 2 of “Preparing
the PEGASO
| Steam Operations”
(
page 1
).
Cleaning the PEGASO
Draining the PEGASO
’s boiler once a month ensures
that the machine operates at optimal conditions.
WARNING: Ensure machine has cooled down before
attempting to clean out the boiler by checking that
the machine doe
sn’t
feel warm on the bottom part
and machine is free from any pressure.
You will need:
- A pan or container that can hold at least 5 litres of
water
- A rag
- Flathead screwdriver
- Supplied socket wrench
1. Ensure the machine isn’t p
lugged into a power
source
and the machine doesn’t feel warm (no
pressure present).
2. Locate the brass boiler plug underneath the
PEGASO and position the PEGASO on top of a pan or
container.
3. Using the supplied socket wrench, unscrew the
boiler plug by slowly turning counter-clockwise. You
may need to use a rag to hold the plug as you unscrew
the plug by hand after loosening using the socket
wrench. Let the water drain, then screw the plug back
on and tighten with supplied socket wrench.
d
