the heater.
Ø
The installation must be equipped with a standard electrical power point with a break contact distance of at least
3mm. The standard power point must be installed by a licensed electrician.
Ø
If the heater is to be mounted on an incline (eg. Sloping or angled ceiling), ensure the electrical connection is
located at that lowest point of the heater.
Ø
Do not connect the appliance to the mains source until it has been installed in its final location and adjusted to the
position it will be used in.
Ø
Do not operate with the cord coiled up as this could cause a buildup of heat, which could pose a hazard.
Ø
The use of an extension cord with this appliance is not recommended.
Ø
Do not allow cord to come in contact with heated surfaces during operation.
Ø
Do not run cord under carpeting, throw rugs or runners etc. Arrange cord away from areas where it is likely to be
tripped over.
Ø
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Ø
Children should be supervised to ensure that they do not play with the appliance
Ø
The appliance is only intended for the purpose described in user manual.
Ø
Do not use appliance or any part of the appliance out of the intended use to avoid risk.
Ø
The use of attachments which are not recommended or sold by the appliance manufacturer may cause a risk of
injury to persons
Ø
CAUTION — some parts of this product can become very hot and cause burns. Particular attention has to be given
where children and vulnerable people are present.
Ø
Install and operate the heater in strictly horizontal position on the ceiling or ceiling structural surface. The thermal
resistance of the ceiling coating and ceiling material should be at least 80 °C.
Ø
WARNING: This heater is not equipped with a device to control the room temperature. This heater is to be used in
open, alfresco environment or large areas with high ceilings. The heater must not be within reach from the floor, as
severe burns may occur due to high surface temperatures. Do not use this heater in small rooms or where the room
or area is occupied by persons not capable of leaving the room on their own, persons who are unable to operate the
heater safely and with the guidelines of the use manual, unless constant supervision is provided.
HOW TO OPERATE THE HEATER
General design layout
①heater radiant surface
②heater operation indicator
③brackets for wall or ceiling mounting
④power cords and plug