Installation and Use
Ankle and Toe Strap Installation
NOTE:
The ladder buckle will need to be tightened against the shoe holder at the end of the adjustment process.
Ensure that the length of strap remaining after the final adjustment is between the ladder buckle and the side-
release buckle and not between the ladder buckle and the body of the shoe holder.
Failing to move the buckle
to the position below will result in slippage and loss of proper adjustment.
Step 1:
With the finger tab towards the side-
release buckle and pad, thread the end of the
strap through the center hole from underneath
and then down through the outside hole. Slide
it down the strap toward the padded section.
Repeat this for both sides of the strap.
Step 2:
Thread the strap end through the
appropriate slot in the toe or ankle section of
the shoe holder and pull it through until the
ladder buckle is close to the slot. Thread the
end of the strap up through the outside hole
and then down through the center hole.
Thread the strap up through the inside hole
next to the serrated rung. In this configuration,
the strap can easily be adjusted for length.
Step 3:
Once satisfied with the adjustment, the
strap can be threaded down through the
outside hole. This will provide tension to retain
the settings and will tuck the strap out of the
way. Should further adjustment be necessary,
pull the strap from the outside hole, make the
adjustment and return it to this position when
finished.
NOTE:
The ladder buckle has two inner
rungs, one of which will have a serrated
edge. If one of the inner rungs does not
have a serrated edge, the buckle is
upside-down and should be turned over
before proceeding.
The ladder buckle
also has a finger tab on it which should be
facing towards the side-release buckle
when in the proper position.
This is
considered the “inside” of the buckle for
the purpose of these instructions.
Side-Release
Buckle
Pad
Elastic
Finger Tab
Serrated Edge
Center Hole
Outside Hole
Inner Rungs
Inside Hole
Ladder Buckle
Side-Release
Buckle
Mounting the Shoe Holder
When the installation of
the straps and pads is
complete,
install
the
foot positioners on the
chair using the included
fasteners as shown here.
¼-20 x ¾” Flat
Head Screws (FHS)
¼-20 Nylon
Lock Nuts
