7
Functioning
6.0
SAFETY
Always have adjustments performed by a trained service technician
.
Height Adjustment
6.2
Add links to adjust height before determining if the arms should be cut. If there are no other
options follow the steps below.
Step 1:
Loosen and remove the M3 x .5 x 12mm FHS with the 2mm T-Handle to remove the collar.
Determine the correct height of the mount that is needed for the user.
Step 2:
Once the desired height has been determined, make cuts on the arms (B). Adjustments to
the height of the arms should only be made in 1/2” increments.
Step 3:
Snap the arms back into the latch (C). Using the 2mm T-Handle, tighten the
M3 x .5 x 12mm FHS back into place.
CAUTION
After cutting adjustments for the arms, smooth all sharp edges.
NOTICE
Cutting the arms should be done only as a last resort
.
Cuts on the arms need to be
made on the hole below the desired mount location. Ensure cut is made through the
middle of the hole.
C
C
B
