Stealth Cam STC-RX24, Инструкция по эксплуатации

Страница: 12 / 54

www.stealthcam.com Page
877-­‐269-­‐8490
12
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
o
PIR PHOTO (default): In this mode the camera will take a designated amount of picture with a
designated time out when the camera senses activity in front of the unit. This mode is available for
both day and night activities.
§
PHOTO RES – 4.0 MP (default): This setting is used to determine the Megapixel resolution of
each image taken by the camera. With this option blinking, use the UP or DOWN arrow key
to move between the options of: 7MP, 5MP, 4MP and 2MP. The higher the resolution of an
image the more space the file will take on the SD memory card.
§
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time
that the camera will wait before it reinitializes its PIR sensor for the next activation. With the
TL mode this setting is only active if TL Delay is set to 1 min or greater. This setting can be
changed between the numbers of 00min 05sec to 59min 59sec. With this option blinking,
use of the UP and DOWN arrows will allow the minutes setting to be changed from 00 to
59. Once this setting is on the appropriate minutes, press the RIGHT arrow key to move to
the seconds setting and it will start to blink. Use of the UP and Down arrows will allow the
seconds setting to be changed from 00 to 59 (05 to 59 if minutes = 00).
§
REDUCE BLUR – ADVANCED (default): This setting is used to determine if the camera should
use the MATRIX Blur reduction technology to dramatically reduce the blur effect resulting in
clearer night time infrared shots. (STANDARD) Minimizes blurring effect in images whlle
retaining long-­‐range night image capability. (ADVANCED) Maximum blur reduction achieved
through a faster shutter speed. This setting my cause a slight reduction in night time range
and increased grain in the image. With this option blinking, pressing the UP or DOWN arrow
buttons will cause the camera to cycle between the two options of STANDARD or
ADVANCED.
§
PHOTO BURST – 1 PHOTO (default): This setting is used to determine the number of photos
the camera will take during its activation. This setting can be changed between 1 PHOTO up
to 9 PHOTOS. With this option blinking, use the UP or DOWN arrow key to move between
the value range in increments of 1.