Stealth Cam STC-G42NG-KPT, Инструкция по эксплуатации

Страница: 13 / 54

www.stealthcam.com Page
877-­‐269-­‐8490
13
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
o
TIME LAPSE (TL): In this mode the camera will take a designated amount of pictures with a
designated time out between the designated hours of operation even if there is no activity in
front of the camera.
"
PHOTO RES – 6.0 MP (default): This setting is used to determine the Megapixel resolution of each image
taken by the camera. With this option blinking, use the UP or DOWN arrow key to move between the
options of: 14MP, 8MP, 6MP or 2MP. The higher the resolution of an image the more space the file will take
on the SD memory card.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the camera
will wait before it reinitializes its PIR sensor for the next activation. With the TL mode this setting is only
active if TL Delay is set to 1 min or greater. This setting can be changed between the numbers of 00min
05sec to 59min 59sec. With this option blinking, use of the UP and DOWN arrows will allow the minutes
setting to be changed from 00 to 59. Once this setting is on the appropriate minutes, press the RIGHT arrow
key to move to the seconds setting and it will start to blink. Use of the UP and Down arrows will allow the
seconds setting to be changed from 05 to 59 (05 to 59 if minutes = 00).
"
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR will be
activated. These distances can vary depending on environmental conditions. This setting will change
between EXTENDED which will trigger about 1/3 further than the STANDARD setting, the STANDARD setting,
or NEAR FIELD that will only trigger on movement closest to the camera.
"
TL DELAY – 00min 30sec (default): This setting is used to set a delay between TIME LAPSE images. This
setting can be changed between the numbers of 00min 05sec to 59min 59sec. With this option blinking, use
of the UP and DOWN arrows will allow the minutes setting to be changed from 00 to 59. Once this setting is
on the appropriate minutes, press the RIGHT arrow key to move to the seconds setting and it will start to
blink. Use of the UP and Down arrows will allow the seconds setting to be changed from 00 to 59 (05 to 59 if
minutes = 00). If the TL Delay is greater than or equal to 1 min, then the PIR sensor will be active between
time-­‐lapse photos.
"
TL START – 06:00PM (default): This setting is used to give the camera the start time for when to start the
time-­‐lapse photography. The default format is in a HH/MM/AP setup, should the time format be in 24 hour
the format it will show HH/MM. With the HH (hour) setting blinking, use the UP and DOWN arrows to allow
the setting to be changed from 1 to 12. Once this setting is on the appropriate hour, press the RIGHT arrow
key to move to the MM (minute) setting and it will start to blink.