④
LINE2: RCA input terminal.
⑤
LINE1: RCA input terminal.
Both LINE1 and LINE2 connect to audio equipment with RCA output (CD
player, etc.) or to REC OUT terminal of amplifiers.
⑥
PARALLEL OUT: RCA output terminal. PARALLEL OUT terminal directly
outputs signals connected to LINE1. It can be used for connection to an-
other driver unit or to the amplifier to drive loudspeaker. Remove the ca-
ble when equipment connected to PARALLEL OUT is not used.
※
On rare occasions, signals from source equipment's are distorted when
the equipment connected to the "PARALLEL OUT" terminal is powered
off. In this case, turn on the connected equipment or remove the cable
from "PARALLEL OUT" terminal.
When adding another SRM-series driver unit using "PARALLEL OUT"
terminal, the power ON/OFF of the added driver unit does not affect
sound if its volume is set to zero.
①
②
③ ④
⑤
VACUUM
TUBE
INPUT
DRIVER UNIT FOR EARSPEAKERS
SRM-T8000
DO NOT OPEN
RISK OF ELECTRIC SHOCK
CAUTION !
PARALLEL OUT
LINE
1
LINE
2
LINE
4
LINE
3
L
L
R
R
R
L
XLR
INPUT
STAX LTD.
MADE IN JAPAN SERIAL No.
GND
50/60Hz 95W
PUSH
PUSH
①
③
②
HOT
SHIELD
COLD
⑥
⑦
⑧ ⑨
①
XLR polarity indication:
XLR balance input polarity is 1-SHIELD, 2-HOT, 3-COLD.
When connecting equipment with 3-HOT, use polarity con-
version adaptor or conversion cable.
②
LINE3: XLR input terminals for equipment provided with
XLR balance output.
③
LINE4: optional slot with cover.
When option card is not equipped, do not remove the
cover. Refer to
the instruction manual of this option card.
⑦
GND: ground terminal.
In case of hum noise connect this terminal to the ground terminal or to
metal part (screw, etc.) of other equipment. Use any available cord for
this purpose.
⑧
AC inlet: insert supplied power cable.
⑨
Foot: Since the degree of adhesion of the foot is very high, be careful
when moving the unit. Lift it up when you move the unit.
⑩
Voltage indication
：
depending on your country’s voltage.
5
⑩
