6
EN
•
When blade is binding, or when interrupting a cut for any reason, release the trigger
and hold the saw motionless in the material until the blade comes to a complete
stop. Never attempt to remove the saw from the work or pull the saw backward
while the blade is in motion or kickback may occur.
Investigate and take corrective
actions to eliminate the cause of blade binding.
•
When restarting a saw in the workpiece, centre the saw blade in the kerf and check
that saw teeth are not engaged into the material.
If saw blade is binding, it may walk
up or kickback from the workpiece as the saw is restarted.
•
Support large panels to minimise the risk of blade pinching and kickback.
Large
panels tend to sag under their own weight. Supports must be placed under the panel on
both sides, near the line of cut and near the edge of the panel.
•
Do not use dull or damaged blades.
Unsharpened or improperly set blades produce
narrow kerf causing excessive friction, blade binding and kickback.
•
Blade depth and bevel adjusting locking levers must be tight and secure before
making cut.
If blade adjustment shifts while cutting, it may cause binding and kickback.
•
Use extra caution when sawing into existing walls or other blind areas.
The
protruding blade may cut objects that can cause kickback.
Safety instructions for circular saws with outer pendulum guard, circular saws with
inner pendulum guard , circular saws with tow guard
•
Check lower guard for proper closing before each use. Do not operate the saw if
lower guard does not move freely and close instantly. Never clamp or tie the lower
guard into the open position.
If saw is accidentally dropped, lower guard may be bent.
Raise the lower guard with the retracting handle and make sure it moves freely and does
not touch the blade or any other part, in all angles and depths of cut.
•
Check the operation of the lower guard spring. If the guard and the spring are not
operating properly, they must be serviced before use.
Lower guard may operate
sluggishly due to damaged parts, gummy deposits, or a build-up of debris.
•
Lower guard may be retracted manually only for special cuts such as “plunge cuts”
and “compound cuts”. Raise lower guard by re-tracting handle and as soon as blade
enters the material, the lower guard must be released.
For all other sawing, the lower
guard should operate automatically.
•
Always observe that the lower guard is covering the blade before placing saw down
on bench or floor.
An unprotected, coasting blade will cause the saw to walk backwards,
cutting whatever is in its path. Be aware of the time it takes for the blade to stop after switch
is released.
•
Additional safety instructions for all saws with riving knife
•
Use the appropriate saw blade for the riving knife.
For the riving knife to function, the
body of the blade must be thinner than the riving knife and the cutting width of the blade
must be wider than the thickness of the riving knife.
CIRCULAR SAW SAFETY RULES
