17
STEP 6 If you are using a battery selector switch, switch it to select one of the batteries. Set the ON/OFF
switch on the PROwatt 1500 to the ON position. Check the meters and indicators on the front panel of
the PROwatt 1500. The voltage bar graph should indicate 12 to 13 volts (24-26V for PW1500/24), de-
pending on the voltage of the battery. If it does not, check your battery and the connections to the
PROwatt 1500. The other indicators should be off.
4.5 Remote Panel
The PROwatt remote switch allows your PROwatt inverter to be switched on/off from a convenient remote loca-
tion while the inverter is mounted out of sight.
Installation Instructions:
1. Cut out the template, located on the back page of the manual (Figure 14), and position it on the wall where the
switch is to be mounted.
2. Mark the location of the two holes, and the square area to be cut out. NOTE: Remote switch assembly re-
quires 0.7”/18mm minimum clear panel depth.
3. Drill two holes, 7/64”/2.8mm diameter and remove the cut-out area.
4. Feed the phone jack connector and wire through the cut-out hole in the panel and route the wire to the inverter
phone jack receptacle.
5. Position the remote switch assembly upright and secure to the panel using the two screws provided. Plug the
phone jack into the inverter.
Operating Instructions:
1. Turn the Inverter Switch “ON”.
2. Press the Remote for “ON” (LED illuminated). Press the Remote for “OFF” (LED off).
3. Leave the inverter switch “ON” (Switching the inverter “OFF” will disable the remote switch).
